Flight Sim Freeware Downloads

Grab Thousands of Microsoft Flight Simulator, Prepar3D and X-Plane freeware for free.

Category: FSX - Early Aircraft
Downloads: Page 4 of 12
Downloads: 118
gotha_wd11_floatplane1

FS2004/FSX Gotha WD-11 Float Biplane. The WD11 was large twin-engined reconnaissance and torpedo-bomber seaplane, It was powered by two 6-cyl 172 hp Mercedes D.III engines, and had a max. speed of 120 kph (75 mph). It could carry a 1598 lb Whitehead torpedo, and saw service in the North Sea and Baltic. Twelve units were built. Gmax model by A.F. Scrub.

Information
Created Tuesday, 14 January 2020 02:17
Filename gotha_wd11_floatplane.zip
Size 7.92 MB
System FSX
Downloads 144
phonix_d11

FS2004/FSX Phonix D.I WW1 Fighter. The Phoenix D.I biplane was intended as a replacement for the Hansa-Brandenburg D.I. Although it was produced in smaller numbers (120 D.I, 45 D.II, and 48 D.IIa fighters) than the Aviatik D.I and did not begin entering service until October 1917, the Phoenix D-series fighters are generally considered the best fighters designed and produced in Austria-Hungary. Gmax model by A.F. Scrub.

Information
Created Friday, 31 January 2020 01:51
Filename phonix_d1.zip
Size 9.45 MB
System FSX
Downloads 189
albatros_d_v1

FS2004/FSX Albatross DVa. The D.V entered service in May 1917 and structural failures of the lower wing immediately occurred. The D.V’s sesquiplane wing layout was even more vulnerable than that of the D III. The outboard sections of the D.V upper wing also suffered failures, requiring additional wire bracing and the fuselage sometimes cracked during rough landings. Owing to these problems, the D.V offered very little improvement in performance to the Albatross D III. Gmax model by A.F. Scrub.

Information
Created Tuesday, 18 February 2020 02:01
Filename albatros_d_v.zip
Size 9.2 MB
System FSX
Downloads 189
albatros_diii1

FS2004/FSX Albatross DIII. Development of the prototype D.III started in late July or early August 1916. Following the successful Albatros D.I and D.II series, the D.III utilized the same semi-monocoque, plywood-skinned fuselage. but adopted a sesquiplane wing arrangement broadly similar to the French Nieuport 11. The upper wingspan was extended, while the lower wing was redesigned with reduced chord and a single main spar. "V" shaped interplane struts replaced the previous parallel struts. Gmax model by A.F. Scrub.

Information
Created Friday, 28 February 2020 01:22
Filename albatros_diii.zip
Size 11.7 MB
System FSX
Downloads 218
bugatti100p_110p1

FSX/Accel Bugatti Concept Racing And Fighter Plane. FSX/Acceleration and optional P3D v3 and FS2004 Bugatti concept racer 100P and fighter plane 110P. Ettore Bugatti has built many fascinating cars and very successful racing cars but he began to build also an extraordinary racing plane in 1938. Lightweight, extreme aerodynamic and at this decade already airbrakes, a V-tail and two 450 hp engines in line should allow up to 800 kmh. The two propeller shafts were on the left and right side of the narrow cockpit and ended at the combined gearbox in front of the cockpit. The racer was never completed, a fighter version was just planned and the replica from 2015 crashed in 2016 with the loss of the airplane and the pilot's life. This add-on with vintage airplanes let you fly safely both versions. Both with photorealistical 2D panels and VC which regards to the replica from 2015. The racer shows in FSX and Acceleration Alpha channeled glossy surfaces. For FS2004 and P3Dv3 are optional textures without Alpha channels included so you can use those models also in that simulator but without shining surfaces. The FDEs, made by our whole team, allows you to reach 450 mph. The exterior textures for both versions are made by Andre Ludick, the panel design and configuration by Michael Pook and the FSDS 3.5 model by Erwin Welker.

Information
Created Saturday, 29 February 2020 01:28
Filename bugatti100p_110p.zip
Size 14.65 MB
System FSX
Downloads 200
fsx_amiot143m1

FSX Update For The French Bomber Amiot 143M. This is the late model of the inter-war Amiot medium bomber, which was used by the French air force in the early days of WWII. The Amiot 143M entered service in July 1935, with deliveries continuing in 1936 and 1937. About six were going to be delivered to the Spanish Republican Air Force at the beginning of the Spanish Civil War. There is no evidence, however, that these obsolete French bombers flew over Spain during the Civil War. This is an FSX update with new and much more realistic panels. Original model by Paul Clawson, modified for FS2004 by Shessie of SOH. Exhaust smoke added. New virtual cockpit, new 2D panel and exhaust smoke configuration by Michael Pook. The model may work in FS2004 and P3D (version 3).

Information
Created Saturday, 29 February 2020 01:43
Filename fsx_amiot143m.zip
Size 25.6 MB
System FSX
Downloads 205
fsx_curtiss_shrike1

FSX Update For The Curtiss A-12 Shrike. The Curtiss A-12 Shrike was a radial-engined derivative of the A-8, which was the first monoplane attack aircraft to serve in substantial numbers with the US Army Air Corps. It was the main aircraft of Army attack aviation strength throughout the early to mid-1930s. However the A12 was rapidly made obsolescent by advances in aviation technology and its service with front-line units of the Army Air Corps was quite brief. By the late 1930s, it had been relegated largely to training units. Except for 20 export versions which were sent to China, the A-12 took no part in aerial combat during World War 2. This package is an FSX update for the version by Shessie and his team of SOH. It features an entirely new virtual cockpit and 2D panel. The original version was designed by David Wooster and his team and this model is also partly based on the FSX version by Paul Clawson. All credits go to the designers mentioned above. New panels and smoke effect by Michael Pook. The model may work in FS2004 and P3D (version 3).

Information
Created Saturday, 29 February 2020 01:50
Filename fsx_curtiss_shrike.zip
Size 25.12 MB
System FSX
Downloads 175
fsx_breguetbidon_updated1

FSX Breguet Super Bidon Updated. The Breguet 19 (Breguet XIX, Br.19 or Bre.19) was a light bomber and reconnaissance aircraft, also used for long-distance flights, designed by the French Breguet company and produced from 1924. This is an update of the Breguet 19, designed and posted by A.F. Scrub some time ago. The package features an enhanced VC and a new 2D panel, both with new gauges. New contact points prevents the plane from going havoc on the runway when started. Smoke, VC and nav lights as well as new camera views added. Credits go to A.F. Scrub for the original model and to Yannis Katehis Tsetsas for the gauge compilation. New 2D panel, VC enhancement and contact points by Michael Pook. The model probably works in P3D/3 and FS2004 as well.

Information
Created Sunday, 01 March 2020 00:42
Filename fsx_breguetbidon_updated.zip
Size 15.72 MB
System FSX
Downloads 209
fsx_dewoitine501_5101

FSX Devoitine 501/510 With New Panels And Smoke. This is the Dewoitine 501/510, previously updated for FSX by A.F Scrub, with new enhanced VC design and all more authentic French gauges for both panels. Smoke and new camera views added. Original model by Craig Richardson, new updates by Michael Pook.

Information
Created Sunday, 01 March 2020 00:53
Filename fsx_dewoitine501_510.zip
Size 12.47 MB
System FSX
Downloads 226
fsx_dewoitine5201

FSX Update For The Dewoitine D520 Regia Aeronautica. This is an FSX update for the FS2004 Dewoitine D-520, designed by F. Giuli, featuring an FSX compatible gauge configuration for the VC and 2D panel. New smoke, VC light and camera views added. Thanks to F. Giuli for the original model. All updates by Michael Pook. The model will very likely work in P3D as well.

Information
Created Sunday, 01 March 2020 01:27
Filename fsx_dewoitine520.zip
Size 16.08 MB
System FSX
Downloads 245

Help Keep Wizzsim Online

  • Bitcoin
  • Ethereum
  • Litecoin
  • Tether
Scan to Donate Bitcoin

Donate Bitcoin to this address

Scan the QR code or copy the address below into your wallet to send some Bitcoin

Scan to Donate Bitcoin Cash

Donate Bitcoin Cash to this address

Scan the QR code or copy the address below into your wallet to send some Bitcoin Cash

Scan to Donate Ethereum

Donate Ethereum to this address

Scan the QR code or copy the address below into your wallet to send some Ethereum

Scan to Donate Litecoin

Donate Litecoin to this address

Scan the QR code or copy the address below into your wallet to send some Litecoin

Scan to Donate Monero

Donate Monero to this address

Scan the QR code or copy the address below into your wallet to send some Monero

Scan to Donate Ripple

Donate Ripple to this address

Scan the QR code or copy the address below into your wallet to send some Ripple

Scan to Donate Tether

Donate Tether to this address

Scan the QR code or copy the address below into your wallet to send some Tether